Parkside PRMA 40-Li C1 Originalbetriebsanleitung Seite 34

GB MT
• After mowing, remove any plant re-
mains that have become stuck to the
wheels, ventilation opening, ejector
opening and blade area using a piece
of wood or plastic. Do not use any
hard or sharp objects as these could
damage the device.
• Check the device before each use for
obvious defects such as loose, worn or
damaged parts. Ensure that all nuts,
bolts and screws are firmly in place.
• Check the covers and protective devic-
es for damage and correct fit. Replace
these if necessary.
Replacing blades
If the blade is blunt, it can be re-sharpened
by a specialist company. If the blade is dam-
aged or unbalanced, it must be replaced.
1. Turn the machine over.
2. Use firm gloves and keep hold of the
blade (23). Use a spanner (SW14) to
turn the blade bolt (24) counter-clock-
wise from the motor spindle (25).
3. Reassemble the new blade (23) in re-
verse order. Make sure that the blade
(23) is positioned correctly (see illustra-
tion ) and that the blade bolt (24) is
tightened.
Storage
Release the wing nuts (2+5) and fold the
upper bar (1) and lower bar (3) together
so that the device takes up less space. The
machine cable must not be jammed when
you do this.
• Store the device in a dry place out of
reach of children.
• Give the motor time to cool off before
you store the device in an enclosed
space.
34
• Remove the rechargeable battery
before storing the device for a long pe-
riod of time (e.g. winter storage).
• The storage temperature for the recharge-
able battery and the device is between
0°C and 45°C. Avoid extreme cold or
heat during storage to ensure the battery
output is not adversely affected.
We are not liable for damage cause by
our devices if this is caused by improper
repair, the use of non-original parts or in-
correct use.
Disposal/environmental
protection
Remove the rechargeable battery before
disposing of the device.
The device, accessories and packaging
should be properly recycled.
Electrical devices do not belong in
domestic waste.
Directive 2012/19/EU on waste electrical
and electronic equipment: Consumers are
legally obliged to recycle electrical and
electronic equipment in an environmentally
sound manner at the end of its life. In this
way, environmentally friendly and resour-
ce-saving recycling is ensured.
Depending on the implementation in national
law, you may have the following options:
• Return to a shop,
• Hand over to an official collection point,
• Return to the manufacturer/distributor.
This does not affect accessories enclosed
with the old devices or tools without any
electrical components.