WAGNER 2341127 Betriebsanleitung Seite 17

EXPLOSION PROTECTION IDENTIFICATION
X marking:
The spray gun corresponds with Ex II 2G X and is, in accordance with
Directive 2014/34 EU, suitable for use in explosion-hazardous areas—as
of type Zone 1. Under certain circumstances, the unit itself may cause
the Zone 1 condition to be in effect.
Any static-electricity discharge from the spray gun is to be diverted to
the grounded high-pressure pump via the conductive high-pressure
hose as stipulated.
The maximum surface temperature corresponds to the permissible
material temperature. This and the permissible ambient temperature
can be found in the Technical Data.
To avoid the generation of machine sparks, prevent impact stresses and any
work on the unit with tools in the explosion-hazardous area.
Residual risks
Residual risks are risks, which cannot be excluded, even when equipment is
used for the intended purpose.
In such cases the applicable areas of the actual residual risks will be pointed
out using warning and/or prohibition signs.
Risk
Injection injury
Explosion or
fire
Hazardous
vapors
AG 19
EN
Source / Cause
High pressure
stream of fluid
Static
electricity or
sparks
Hazardous
vapors from
spray material
Impact
Severe injury or
amputation
Severe injury
Severe injury
Preventative
measures
NEVER aim the
gun at any part
of the body
Use well
ventilated area
Ground the
spray gun
Use well
ventilated area
Use mask
Can occur
during:
Setup,
Operation
Operation
Operation
17