Symbols And Technical Data; Power Supply - EINHELL 15.460.32 Bedienungsanleitung

Anleitung CEN 160-1F SPK 1
GB
suitable clothing and a face guard.
2. Slip-on gloves made of a suitable material
(leather) must be worn on both hands. They
must be in perfect condition.
3. Suitable aprons must be worn to protect clothing
from sparks and burns. A safety suit and, if
necessary, head protection must be worn if
required by the type of work in question, e.g.
overhead welding.
Protection from radiation and burns
1. Provide information about the risk to eyes at the
working site in the form of a poster with the
wording "Caution – do not look at the flames".
Workplaces are to be screened off wherever
possible so that personnel in the vicinity are
protected. Unauthorized persons are to be kept
away from the welding work.
2. The walls in the immediate vicinity of stationary
workplaces should not have a light color or a
sheen. Windows up to head height are to be
protected against radiation passing through them
or reflecting off them, for example by coating
them with a suitable paint.

4. SYMBOLS AND TECHNICAL DATA

EN 50 060 European standard for welding
sets for manual arc welding with
limited on time.
Single-phase transformer
1 1
50 Hz Mains frequency
U 1 Mains voltage
I max Rated maximum mains current
Fuse with rated value in A
U 0 Rated idling voltage
I 2 Welding current
Ø mm Electrode diameter
nc/nc 1 Number of welding electrodes
that can be melted.
a) from a cold state up to the trip
point of the temperature monitor
(nc) and
b) within the first hour from the
12
28.10.2004 14:44 Uhr Seite 12
cold state (nc 1 )
nh/nh 1 Number of welding electrodes
that can be melted
a) in a hot state between the
temperature monitor switching
on and off (nh)
and
b) over a period of one hour in a
hot state from being switched on
again (nh 1 )
Symbol for falling characteristic
curve
Symbol for manual arc welding
with sheathed rod electrodes
Single-phase mains connection
1
IP 21 Protection type
H Insulation class
The set is interference-suppressed in compliance
with EC Directive 89/336/EEC
Mains connection: 230 V / 400 ~ 50 Hz
Welding current (A) at cos Ê = 0.73:
Electrodes (Ø mm):
2,0 (n / n : 50/50 / n
c c1
2,5 (n / n : 21/33 / n
c c1
3,2 (n / n : 8/18 / n
c c1
4,0 (n / n : 3/8 / n
c c1
Idling voltage (V):
Power input: 4 kVA at 80 A cos µ = 0,73
Fuse (A):
5. Assembly Instructions
See Figure 5-12.

6. Power supply

This welding set can be operated with a rated
voltage of 230 V and 400 V. The desired rated
voltage can be set by means of the rotary switch
illustrated in Figure 2-4. Please follow the operating
instructions, as described below:
Figure 2:
The initial position of the rotary switch is set to 400
55 - 160 A
/ n :50/50)
h h1
/ n :8/24)
h h1
/ n :3/15)
h h1
/ n :1/7)
h h1
48
16