Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Commissioning and operation
5. Commissioning and operation
Personnel: Skilled personnel
EN
Check the instrument for any damage that may have been caused.
In the event of any damage, do not commission the instrument and contact the
manufacturer immediately.
5.1 Mounting preparation
Ensure that the sealing faces of the vessel or vibrating level switch are clean and do
not show any mechanical damage. Sensor components (fork body), process seals
and process interfaces must be in accordance with the installation conditions, and
the process pressure, the process temperature and the medium characteristics must
correspond to the parameters given on the product label.
14
DANGER!
Danger to life from explosion
Through working in flammable atmospheres, there is a risk of explosion
which can cause death.
▶
Only carry out set-up work in non-hazardous environments.
WARNING!
Physical injuries and damage to property and the environment
caused by hazardous media
Upon contact with hazardous media (e.g. oxygen, acetylene, flammable
or toxic substances) or harmful media (e.g. corrosive, toxic, carcinogenic,
radioactive), there is a danger of physical injuries and damage to
property and the environment.
Hazardous media may adhere to or escape from the instrument should a
failure occur.
▶
For these media, in addition to all standard regulations, the
appropriate existing codes or regulations must also be followed.
▶
Wear the requisite protective equipment, see chapter 2.4 "Personal
protective equipment".
On the wetted parts of the instrument, small residual amounts of the
adjustment medium (e.g. compressed air, water, oil) can adhere from
production. With increased requirements for technical cleanliness,
suitability for the application must be checked by the operator before
commissioning.
WIKA operating instructions, models TLS-S, TLS-C, TLS-H
Werbung
