Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
INSTALLATION, USE AND MAINTE-
NANCE INSTRUCTIONS
SAFETY INFORMATION
THIS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY
IF YOU SMELL GAS:
1. TURN OFF THE GAS SUPPLY
2. EXTINGUISH ANY OPEN FLAME
3. OPEN THE LID
4. IF ODOUR CONTINUES, IMMEDIA-
TELY CALL YOUR GAS SUPPLIER
OR THE FIRE DEPARTMENT
• THE USER IS RESPONSIBLE FOR
PROPER INSTALLATION AND APPRO-
PRIATE USE OF THE BARBECUE.
• FAILURE TO COMPLY WITH THE
INSTRUCTIONS IN THIS MANUAL MAY
RESULT IN A DANGEROUS FIRE OR
EXPLOSION.
• FAILURE TO FOLLOW THE INSTRUC-
TIONS IN THIS MANUAL MAY RESULT
IN SERIOUS INJURIES AND MATERIAL
DAMAGE.
• USE PROTECTIVE GLOVES WHEN
HANDLING PARTICULARLY HOT PARTS
• MODIFICATIONS TO THE BARBECUE
ARE DANGEROUS AND NOT PERMIT-
TED. THIS APPLIANCE MUST BE IN-
STALLED IN ACCORDANCE WITH THE
APPLICABLE PROVISIONS.
• STORE THE CYLINDER OUTDOORS IN
A WELL-VENTILATED AREA
• NEVER STORE OR USE GASOLINE OR
OTHER FLAMMABLE VAPOURS AND
LIQUIDS IN THE VICINITY OF THIS OR
ANY OTHER BARBECUE.
• KEEP COMBUSTIBLE MATERIAL AT
LEAST 76 CM AWAY FROM THE BAR-
BECUE
• USE THE BARBECUE ONLY OUT-
DOORS IN A WELL-VENTILATED AREA
AND AT LEAST 3 M FROM ANY DWEL-
LING OR BUILDING.
• DO NOT USE THIS APPLIANCE UNDER
AN OVERHANGING STRUCTURE OR
FOLIAGE
• DO NOT USE THE BARBECUE ON
A BOAT OR OTHER RECREATIONAL
VEHICLE
• DO NOT USE THE BARBECUE IN A GA-
RAGE, SHED, CORRIDORS OR OTHER
ENCLOSED AREAS
• NEVER LEAVE THE BARBECUE UNAT-
TENDED WHEN IN USE
• DO NOT OBSTRUCT THE FLOW OF
COMBUSTION AND VENTILATION AIR
TO THE BARBECUE
MAN_NINHO_BERO_BBC130807_A.indd 31
• DO NOT USE THE BARBECUE WHEN
YOU HAVE CONSUMED ALCOHOL OR
TAKEN DRUGS
• ACCESSIBLE PARTS MAY BECOME
VERY HOT. KEEP (YOUNG) CHILDREN
AND ANIMALS AWAY FROM THE BAR-
BECUE.
• DO NOT MOVE THE BARBECUE WHEN
IN USE
• PARTS SEALED BY THE MANUFACTU-
RER OR HIS REPRESENTATIVE MAY
NOT BE ALTERED BY THE USER.
• ALWAYS PLACE THE BARBECUE ON
FIRM GROUND AWAY FROM OBJECTS
THAT MAY CATCH FIRE OR MELT.
GAS CONNECTION
GAS CYLINDER
Always use an approved cylinder that
complies with all national provisions and
standards.
• We recommend this product is con-
nected to PROPANE
• Always keep the cylinder in a stable
and upright position.
• Be careful when handling the cylin-
der valves
• Never connect a cylinder without
regulator to the barbecue.
• Never connect a non-regulated
cylinder to the barbecue.
• Always close the cylinder valves
when the barbecue is not in use
• Never place the spare cylinder under
or next to a barbecue in use
• Never expose the cylinder to exces-
sive heat or direct sunlight
• Change the flexible tube if required
by national regulations
HOSE AND REGULATOR
The hose and regulator are not supplied
by the manufacturer. You may only use
a combination of hose and regulator if
this complies with all local and national
standards and rules and corresponds with
the connections on the gas cylinder used
and the gas type/nominal pressure given
on the barbecue. Keep the hose as short
as possible.
• Never connect the barbecue to a
non-regulated gas supply. Never try
to alter the hose or regulator in any
way whatsoever.
• Prior to each use of the barbecue,
check the hose over its full length
for any damage (cracks, tears, burnt
sections) or excessive wear. When
you notice any damage or wear,
replace the hose before using the
barbecue, in accordance with the
national standards
• Fat (or any other hot substance)
must never fall onto the hose, and
the hose must never come into
contact with any hot points on the
barbecue
• The connector of the regulator must
be protected when it is not connec-
ted to the cylinder
• Ensure that the hose does not drag
on the ground, because this can
cause problems for the airtightness
of the connection.
• Do not distort the hose when con-
necting or disconnecting the cylin-
der
• The maximum permissible length of
the hose is 1.5m
CONNECTING THE GAS CYLINDER
On some gas pressure regulators you must
press ON to connect and OFF to discon-
nect; other regulators have a nut and a
left-handed screw thread to connect the
regulator to the gas cylinder. Follow the
instructions for the gas pressure regulator
in question.
1. Connect the hose to the gas regulator.
a. Push the hose over the regulator
and tighten up the span ring.
b. Wind the gas hose over the regula-
tor, first by hand and then fasten it
firmly using an adjustable spanner.
2. Connect the gas regulator to the cylinder.
a. Screw the gas pressure regulator
connector to the right on the tank
8/08/13 14:23
Werbung
