Herunterladen Inhalt Inhalt Diese Seite drucken

GRAUPNER COMPACT CONTROL 44S Bedienungsanleitung Seite 22

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Flowchart
Auto Set
D
Acro Inrunner
D
Acro Outrunner
D
Glider Inrunner
D
Glider Outrunner
D
Heli Constant RPM
D
Heli constant RPM
3D
D
Remark 2: Multi motor models
We recommend to use the same controller type for each motor. In case of Compact Con-
trol 44S controllers switch on only one BEC.
The switches of the other controllers remain in the "SWITCHED OFF" position.
When using controllers with BEC it is generally necessary to use only one common flight
battery. If we want to utilize 2 and more batteries these must be connected in parallel.
TIP:
If you do not know the pole number of your motor please contact the manufacturer. If you
own a revolution counter and know the gear ratio of your gear box (direct 1:1) you will be
able to find the pole number as follows. Switch on the motor and with the help of the revo-
lution counter measure the maximum propeller (rotor) rpm. Connect the PROGRAMMER-
Box and go in the menu MEASUREMENT to the maximum propeller RPM display (Max.
Prop RPM). If the shown value does not correspond with your measured value check the
gear ratio setting (Gear) and change the pole number inputs until your measured RPM
will be identical with the value in the PROGRAMMER-Box display (Max. Prop RPM). As a
result you will obtain the pole number of your motor (Motor Pole No.)
22 Flowchart
We apply this mode for putting the controller into operation in
a fast and simple way for instance after loosing track during
setting. The setting content is practically the same as setting with
the help of R/C equipment. Confirmation of the setting is carried
out by means of the push-button R.
Remark 1: Extending the battery cables.
As a matter of principle only cables from the battery to the
controller can be extended. If the extension is larger than 20 cm
it is unavoidable to connect between the cables a low impedance
electrolytic power capacitors of a capacity 100-2200 μF #91539.
xx. These capacitors must be inserted between every cable
section longer than 25-30 cm.
ID # 0058019

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis