bürkert 0301 Bedienungsanleitung Seite 5

→
Connect terminals.
→
Connect protective conductor.
→
Attach seal and check for correct fit.
→
Mount cable plug (DIN EN 175301-803 (DIN 43650), shape B) and
screw tight, observing the maximum tightening torque 1 Nm.
→
Check electrical continuity between coil and valve body (protective
conductor function).
7 MainTenance, TrouBleShooTing
Danger!
Risk of injury from high pressure in the system or device.
▶ Before working on the system or device, switch off the pressure
and vent and drain lines.
Risk of injury due to electric shock.
▶ Before working on the system or device, switch off the power
supply and secure to prevent reactivation.
▶ Observe applicable accident prevention and safety regulations
for electrical equipment.
If switched on for a prolonged time, risk of burns or fire due to
hot device surface.
▶ Keep the device away from highly flammable substances and
media and do not touch with bare hands.
Risk of injury from improper maintenance work.
▶ Maintenance may only be carried out by authorized technicians
and with the appropriate tools.
▶ Secure system against unintentional activation.
▶ Following maintenance, ensure a controlled restart.
english
12
8 Spare parTS
CautIon!
Risk of injury and/or damage due to the use of incorrect parts.
Incorrect accessories and unsuitable spare parts may cause injuries
and damage the device and the surrounding area.
▶ Use original accessories and original spare parts from Bürkert only.
6 DiSaSSeMBly
Danger!
Risk of injury from high pressure in the system or device.
▶ Before working on the system or device, switch off the pressure
and vent and drain lines.
Risk of injury due to electric shock.
▶ Before working on the system or device, switch off the power
supply and secure to prevent reactivation.
▶ Observe applicable accident prevention and safety regulations for
electrical equipment.
Risk of injury from improper disassembly.
▶ Disassembly may only be carried out by authorized technicians
and with the appropriate tools.
→
Turn off the pressure and vent the lines.
→
Switch off the power supply.
→
Remove cable plug (if required).
→
To remove the valve, loosen the two screws only.
→
Remove valve from manifold.
english
7.1 Malfunctions
If malfunctions occur, check whether
→
the device has been installed according to the instructions,
→
the electrical and fluid connections are correct,
→
the device is not damaged,
→
all screws have been tightened,
→
the voltage and pressure have been switched on,
→
the pipelines are clean.
Malfunction Possible cause
Valve does Short circuit or coil interrupted
not switch
Core or core area dirty
Valve does Inner compartment of the valve is dirty
not close
If the valve still does not switch, please contact your Bürkert Service
representative.
9 TranSporTaTion, STorage,
DiSpoSal
note!
Transport damage.
Inadequately protected devices may be damaged during
transportation.
▶ Protect the device against moisture and dirt in shock-resistant
packaging during transportation.
▶ Prevent the temperature from exceeding or dropping below the
permitted storage temperature.
Incorrect storage may damage the device.
▶ Store the device in a dry and dust-free location.
▶ Storage temperature -40 – +80 °C.
Damage to the environment caused by device components
contaminated with media.
▶ Dispose of the device and packaging in an environmentally friendly
manner.
▶ Observe applicable disposal and environmental regulations.
english
Type 0301
11
13