Silvercrest KH 2381 Bedienungsanleitung Seite 55

Face plate
Putting the face plate on
• Place the face plate with the left side in the frame
first. Then firmly press the right side until it locks
into place.
• Check to make sure that the face plate is firmly
and correctly installed in the frame. If the face
plate is incorrectly installed it can result in mal-
functions when operating the car radio.
Note
The car radio will only function with the face
plate connected.
Removing the face plate
• Press the button to unlock
• To remove the face plate first tip it slightly forward
and pull the right side away first and then the
left side.
All manuals and user guides at all-guides.com
Remote control
Inserting the battery
Remove the supplied battery from the packing.
To insert the battery and/or change the battery
proceed as follows:
• Pull the battery compartment out of the remote
• Remove the depleted battery and insert a new
the face plate. • Slide the battery compartment back into the re-
Using the remote control
• Point the remote control to the infrared sensor
• You can use the remote control for distances of
- 53 -
Note
When the face plate is not inserted into the frame
the theft protection LED on the device blinks.
To safeguard the face plate always keep it stored
in its case.
control by first pressing the lateral locking device
and then pulling the battery compartment out.
battery of the type CR2025 (Button cell) into the
battery compartment. Make sure that the battery
is inserted in accordance with its correct polarity.
mote control.
on the front panel of the device.
up to approx. 8 m from the device.