Planing Of Workpieces With A Small Cross-Section; Thicknesser - Holzmann K5 315VF-2000 Originalbetriebsanleitung

14.3.4 Planing of workpieces with a small cross-section

 When dressing workpieces with small cross-section, an additional
wood bracket is screwed!
Fasten the wood angle or the like with pliers on the crosscut
fence as shown
 Replace When dressing the workpiece at the jointer and press
workpiece slowly and evenly against the additional angle and
wood jointer.

Thicknesser

14.4
For thicknessing workpieces conversion work on the planer are necessary.
Conversion work for thicknessing
Conversion work with connected machine:
Therefore:
Off before remodeling machine with stop button and disconnect from the power
supply
 Off Planer with Stop button and disconnect from the power supply.
 Removing the angle stop and swing plane shaft cover up in top position.
 Remove the hose of dust extraction
 Eccentric lock unlock (A)
 Open as shown planer
 dust box by 180 ° pivot upward
 Dust extraction hose the Remount
HOLZMANN Maschinen Austria
A
www.holzmann-maschinen.at
W A R N I N G
5-fach Kombination / combined 5-operation machine K5 315VF-2000
ASSEMBLY
Seite 52