Wolf Garten 2.53 B Gebrauchsanweisung Seite 14

Maintenance
Disconnect spark plug cap and starter key before proceeding
Clean mower thoroughly after each mowing with cloth or brush.
Do not spray with water. Keep mower in a dry room.
Change oil only
While engine is warm and fuel tank empty.
Change oil after the first 5 working hours. Thereafter chane
engine oil every 25 working hours and at the end of the mowing
season. Change engine oil more frequently if working under
extreme and dusty conditions. To drain the engine oil, remove
oil filler cap, tilt machine slowly to side and allow oil to drain
from the crankcase through the filler.
Cleaning of Spark Plug
Check and clean regularly, reset plug gap as required (0,76 mm).
Cleaning of air filter
Refer to the engine manufacturer's handbook supplied.
Cleaning operations and blade change (fig. W1)
1. Remove spark plug connector.
2. djust cutting height to highest position.
3. For cleaning and changing the blade, tip the mower to the
side as illustrated.
Sharpening and changing blade (fig. W2)
Gloves should be worn at all times when working on the
blade. Remove ignition key and spark plug lead when
working on the blade.
Faults and how to remedy
Problem
Motor does not start or has
no power:
Uneven cutting:
When in doubt, always consult a WOLF service workshop. Important: switch off the mower and disconnect the spark plug lead
before inspecting, cleaning or working on the blades.
Guarantee terms
Please carefully retain the guarantee card completed by the seller,
or the proof of purchase.
The company WOLF-Garten provides a guarantee for 24 months from the
date of purchase. This guarantee is in accordance with the relevant state of
technology and the utilisation purpose / area of application. The consumer's
statutory rights are not affected by the following guarantee guidelines.
Pre-conditions for the 24-month guarantee entitlement:
- Deployment of the device solely for private use.
The guarantee is reduced to 12 months in the commercial sector
or leasing business.
- Proper handling and observance of all information given in the
operating manual, which forms part of our guarantee terms.
- Observance of the prescribed maintenance intervals.
14
All manuals and user guides at all-guides.com
Possible cause
• Insufficient fuel in the tank
• Spark plug lead not connected
• Spark plug out of order
• ir filter dirty or oily
• Throttle lever not at „Run"
• Blade fastening screw loose
• Clutch linings worn
• Cutting height misadjusted
• Blunt blades
• ir / duct catcher bag blocked
Blade should always be sharpened by an approved Service
Centre. Change blade according to drawing.
Information for Service Centre, blade retaining screw to be
tightened to: screw = 38-42 Nm.
djusting the clutch Bowden cable (Fig. W3/B7)
1. Lift drive bar (B7, 3) about 2 cm and hold in position.
2. Loosen lock nut (W3, 1).
3. Turn adjusting screw (W3, 2) counter-clockwise until the
drive wheels block when the mower is pulled backwards.
4. Re-tighten lock nut (W3, 1).
Winter storage
• Drain fuel tank.
• Drain carburettor
- therefore start engine, keep it runninug until it automaticalli
switches off.
• Clean the whole machine thoroughly
• Change oil, 4-stroke engine.
• Prepare engine for winter storage as follows:
- Remove spark plug
- Poor one spoon full of engine oil into spark plug hole
- Pull starter rope slowly to distribute oil evenly inside cylinder
- Replace spark plug but do not connect spark plug lead
- Pull starter rope until resistance is felt (valves are now closed)
• Store mower in a cool and dry place.
We recommend: Have your mower thoroughly checked once a
year by approved Service gent.
WOLF
service-workshop
---
---
---
---
---
X
X
---
X
---
- No unauthorised alteration of the design.
- Installation of original WOLF replacement parts / accessories.
- Presentation of the completed guarantee card and/or proof of purchase.
This guarantee does not extend to normal wear-and-tear on blades,
blade mounting components or friction disks, V-belts/toothed
belts, running wheels/tyres, air filters, spark plugs and spark plug
connectors. ny guarantee claim shall be immediately void in the
event of unauthorised repairs. Faults and defects which can be traced
to material or manufacturing faults will be rectified exclusively by our
contracted workshops (the seller has the right to remedy a defect) in
your vicinity, or by the manufacturer if the latter is closer. ny claims
going beyond the provision of a guarantee are ruled out. There is
no entitlement to a replacement.
reported not to us but to the shipper in question since, otherwise, any
compensation claims vis-à-vis the shipper would be voided.
Remedy (X) by:
Yourself
X
X
X
X
X
---
---
X
---
X
ny transport damage should be