Hilti PM 30-MG Original Bedienungsanleitung Seite 22

5.5 Switching the laser beams on
1. Set the selector switch to the
▶ The vertical laser lines are switched on.
2. Press the line mode button repeatedly until the desired line mode is set.
▶ The operating modes change in the following sequence and the sequence repeats itself: vertical lines,
vertical side line, horizontal line, vertical and horizontal lines.
5.6 Switching the laser beams off
1. Set the selector switch to the OFF position.
▶ The laser beam is switched off and the pendulum is locked.
CAUTION
Risk of injury by unintended starting!
▶ Before inserting the battery, make sure that the product is switched off.
2. The laser beam is switched off automatically when the battery is low.
5.7 Setting the laser beam for the "Inclined line" function
1. Set the selector switch to the
2. Press the line mode button repeatedly until the desired line mode is set. → page 16
When the "Inclined line" function is active, the pendulum is locked and the laser is not leveled.
The laser beam(s) blink every 5 seconds.
5.8 Activating or deactivating laser receiver mode
The range of the laser receiver might be restricted on account of the design-related asymmetry of the
laser power and possible disruptive external light sources.
To optimize the range, work on a strong side of the line laser and avoid working in direct light. The
strong sides are the rear, where the battery is mounted, and the opposing front.
1. To activate the receiver mode, press the receiver mode button. The laser beam flashes five times as
confirmation.
2. Press the receiver mode button again to deactivate the receiver mode.
Receiver mode is deactivated when the tool is switched off.
5.9 Examples of applications
5.9.1 Transferring heights
5.9.2 Setting up drywall track for a partition wall 3,
5.9.3 Vertical alignment of pipes
5.9.4 Aligning heating units
5.9.5 Aligning door and window frames
5.10 Checking
5.10.1 Checking the plumb point
1. In a high room (for example in a stairwell with a height of 10 m), make a mark (a cross) on the floor.
2. Place the tool on an even, level surface.
3. Switch the tool on and unlock the pendulum.
4. Position the tool so that the lower plumb beam coincides with the center of the cross marked on the
floor.
5. Mark the top point of intersection of the laser lines on the ceiling.
16 English
position (ON / unlocked).
position (ON / locked).
2
5
6
7
8
4
2243556
*2243556*