Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.2
Mounting / dismounting, operating position
7.2.1 Assembly
This device is suitable for outdoor and indoor use.
7.3
Installation
Danger of electric shock due to energised parts!
Non-compliance can result in minor injuries!
• All connections must be disconnected from the power supply.
• Secure the connections against unauthorized switching.
Explosion hazard due to insufficient protective measures!
Non-compliance results in severe or fatal injuries.
• Select suitable cables to ensure that the maximum permissible
• When using core end sleeves, attach them using a suitable tool.
• Use only separately tested cable entries and stopping plugs with an
• The conductor insulation must be touching the terminal.
• Do not damage the conductor (e.g. nicking) when stripping it.
• Always connect the protective conductor.
Two conductors can be installed under one connection terminal. Material and
cross section of both conductors must be identical.
The conductors can be connected without any special preparations.
Main contacts
150663 / 8570609300
2017-04-25·BA00·III·en·06
conductor temperatures are not exceeded.
EU Type Examination Certificate.
Dimensions [mm]
A
B
180
100
Mounting and installation
CAUTION
DANGER
• Open the enclosure. Guide the
cables through the cable entry into
the connection chamber.Strip the
cables.Insert the conductors into the
corresponding terminals and clamp
them (for tightening torque, see
chapter "Technical data"). Insert the
stripped cable ends completely
under the clamping plate. Check if
the conductors have been clamped
properly. Align the conductors.
Make sure that the clamping points
are not under tension.Tighten the
cable glands. Close the enclosure
(for the tightening torque, see
chapter "Technical data").
SolConeX Coupler Socket
Series 8570/16
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
11
Werbung
