Omit Zones; Install User - Abus SECVEST 868 Bedienungsanleitung

17.4 Omit zones

If necessary, you can remove zones from surveillance (e.g., if a detector is defective
or a zone cannot be closed). Select the second item from the user menu and you
see the following graphic display:
Confirm this menu item with the control button
you receive the following graphic display:
The system shows you all zones that have been trained. Press the control button
to select the zone whose settings you want to change. The setting means: I =
Monitored / O = Blocked (not monitored)
Change the setting with the control button
the setting changes.
When you have made your setting, end your input by pressing the control button
under the setting "Done".
When the radio alarm system is activated, these zones are not monitored. Next
time the alarm system is deactivated, these zones are automatically included again
and have to be removed from monitoring manually.
under the word "Select" and
under the word "Change" and

17.5 Install user

As administrator, you can use your code (master code) to install further users for
the radio alarm system. You can install up to 50 users on the system. This menu
item is also used for teaching the remote control, the emergency and panic
detectors, and the proximity tag. Select the third item from the user menu and
you see the following graphic display:
Confirm this menu item with the control button
you receive the following graphic display:
You can now edit user settings, add a new user or delete an existing user with all
settings.
To edit user settings, use the control button
confirm your input by pressing the control button
19
under the word "Select" and
to select "Edit User" and
under the word "Select".