Setting The Dip Switches; Setting Up The Zero Point - HBM RM220 Bedienungsanleitung

RM4220
Fig. 5.2: Motherboard and position of DIP switch with opened housing, factory set­
ting is shown in the image and in brackets

5.2 Setting the DIP switches

• OUTPUT sets the voltage output:
"10 V and 4 ... 20 mA
0 ... 10 V and 4 ... 20 mA (switch position as in image, factory setting)
• EXCITATION sets the excitation voltage for the transducer:
5 V
DC
10 V (switch position as in image, factory setting)
DC
• 6 WIRES and 4 WIRES change the switching type (both switches must
have the same position):
Six‐wire configuration
Four‐wire configuration (switch position as in image, factory setting)

5.3 Setting up the zero point

The zero point is set with ZERO (Fig. 5.2) and the Zero potentiometer (Front).
A1091-4.0 en/de
ZERO GAIN
Output voltage (0 ... 10 V)
Excitation voltage (10 V)
Four‐wire or six‐wire
configuration (four‐wire)
Resistors for filter (SMD)
Resistors for filter
(conventional technology)
13
HBM