Breezy RelaX2 Gebrauchsanweisung Seite 17

Options – Castor adapter
SEAT HEIGHT ADJUSTMENTS:
The seat height is determined by the castor and rear wheel
position. The seat height can be adjusted by using different sizes
of rear wheels and by altering the position of the rear wheels
and the castors and by using spacers.
CAUTION!
• After adjusting the seat height, all screws must be re-tightened.
• The castor angle should be set at 90°.
• Therefore the front and rear seat height needs to be always
the same.
Options - Backrest
COMFORT BACK
(Fig. 17 to 19).
The comfort back offers lateral support and comfortable seating
over long periods of time.
The back shell can be removed by turning the knobs (1) and push-
ing them outwards. By moving the back shell forward-upward it will
be released form the guiding hooks.
The cushion is fixed by velcro and can be removed as well.
WARNING!
When fixing the back make sure that the shell is properly
attached to the guiding hooks and locked correctly.
Fig. 17
Fig. 19
Fig. 18
1
Options - Backrest
HEIGHT-ADJUSTABLE BACKREST
The height of the backrest can be set to 4 different positions .
Release and remove the bolts (1), and move the guiding hooks
(2) to the desired position. Tighten up the bolts again,
(Fig. 20).
TRUNK SUPPORT
The trunk support can be adjusted in angle, depth and height. It
can be swing away by turning the release lever (1). (Fig.21)
Fig. 20
1
2
RECLINING BACK (0° - 35°)
CAUTION!
Before operation please remove the locking pin (1), (Fig.22).
By pulling lever (2), you can release the backrest and then move
it to the desired position. On releasing the lever (1) the backrest
will automatically lock into place
(Fig. 23).
WARNING!
• It is recommended that the reclining back is used in
conjunction with anti-tip tubes (maximum ground clearance 3 –
5 cm).
• Never adjust the back angle if the wheelchair is on a slope.
• Ensure the locking pin is put back in place.
Fig. 22
2
1
Fig. 21
1
Fig. 23
1
17
RelaX
2