Bt Select [Bts] - Canton VRA 3 Bedienungsanleitung

English
Note: • If a signal is being transmitted via Bluetooth wireless technology, the BRA 3 / VRA 3 will not send a pairing request to a second
mobile device, even if the automatic [AUT] setting is selected.
• If the input Bluetooth is not selected, neither automatic nor manual pairing is possible. To achieve pairing independent of the
selected input, the BT Select [BTS] function must be set to AUT. Please refer to the next chapter.
• For the requirements for a successful pairing process, please see chapter "Playback via Bluetooth® wireless technology.

BT Select [BTS]

When this function is enabled [AUT], the speaker automatically switches to the BT input whenever it detects an audio signal from the
mobile device. If this function is deactivated [MAN], the input must be selected manually.
To activate / deactivate this function, proceed as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu Bluetooth Setup [BT] and confirm with the "OK" button.
2
Select the menu item BT Select [BTS] and confirm with the "OK" button.
3
Select the wanted parameter [MAN] resp. [AUT] using the "+" or "-" key.
4
Confirm by pressing the "OK" button. To leave the menu, press the"M" button.
5
Note: • Depending on the mobile device used, the speaker may also switch to the BT input when typing a message or when other
system tones occur - when the automatic [AUT] function is activated. A time delay of 5 seconds is programmed to avoid
continuous switching (e.g. on arrival of a message).
• If the BT Select function is activated [AUT], the BT input cannot be selected via the Input buttons up resp. down, any longer. In
this mode, the speaker can be paired with the mobile device, regardless of the selected signal input.
88