STIEBEL ELTRON DHB 18 ST Trend Bedienung Und Installation Seite 31

INSTALLATIoN
Installation
Fitting the wall mounting bracket
f Mark out the holes for drilling using the installation tem-
plate. If the appliance is to be installed on finished walls, also
mark out the fixing hole in the lower section of the template.
f Drill the holes and secure the wall mounting bracket at
2 points using suitable fixing materials (screws and rawl
plugs are not part of the standard delivery).
f Fit the wall mounting bracket.
Installing the twin nipples
Property damage
!
Carry out all water connection and installation work in
accordance with regulations.
f Seal and insert the twin nipples.
Making the water connection
2
1
3
24
5 Nm
5 4
1 DHW with tee
2 Gasket
3 Cold water with 3-way ball shut-off valve
4 Strainer
5 Plastic profile washer
f Secure the tee and 3-way ball shut-off valve, each with a flat
gasket, to the twin nipple.
Property damage
!
The strainer must be fitted for the appliance to function.
f When replacing an appliance, check whether the
strainer is installed.
www.stiebel-eltron.com
2
24
5 Nm
Removing the flow limiter
Notice
If you are using a thermostatic valve, you must not re-
move the flow limiter.
If the flow rate is too low, remove the flow limiter. To do this,
remove the function module from the appliance back panel.
2.
3.
4.
f Release the locking tab.
f Push the function module on the back panel gently
backwards.
f Remove the function module from the appliance back panel
by pulling it slightly forwards and lifting it off.
1.
DHB ST Trend | 31