Product Assembly; Folding The Drone; Propeller Installation - SYMA X200W Bedienungsanleitung

3.0 Product Assembly

3.1 Folding the drone

1. Unfold the arms in the direction of the arrow

3.2 Propeller Installation

Detaching the propellers
1
2
Remove the screws and the holder in the
direction of the arrow, and then detach
the propellers.
A
B
Note:
!
1. Please make sure that the propellers are installed in the correct position. If the installation is incorrect,
the drone will not be able to fly normally.
2. Since the propellers are thin, please be careful when installing them in case of accidental scratches.
3. Please use the propellers provided by our manufacturer.
4. The propellers are consumables, if necessary, please purchase additional accessories.
2. Fold the arms in the direction of the arrow
1
3
Place the propellers on the arm of the drone
in the direction of the arrow, place the holder
then tighten the screws.
B
Referring to the figure below, install the
label "A" propeller and label "B" propeller
in the corresponding positions, and use a
screwdriver to tighten the screws.
A
Re-installing the propellers
3
2
6