TR-Electronic 582 Serie Bedienungsanleitung Seite 47

4.2.2 Dowel pin / groove insert
➢ The measuring system must be fixed via a dowel pin on the drive side, see Figure 8.
➢ The specifications for the dowel pin can be found in chapter: 4.2.1.1 "Requirements for the
customer shaft".
➢ The assembly instructions for the clamping ring assembly must be observed, see chapter: 4.2.1
"Mounting of the clamping ring (general)".
Figure 8: Mounting with dowel pin / groove insert, principle illustration
4.2.3 Spring metal sheet as torque holder
➢ The ambient conditions, the shaft load and the axially and radially permissible shaft movement
tolerances specified in the article number-specific data sheet must be observed.
➢ Stress-free mounting in idle state.
➢ Slide the measuring system onto the drive shaft.
➢ Each wing of the torque holder must be fastened to the machine with at least one M3 cylinder
head screw in combination with a suitable washer.
The spring metal sheet must not be warped or prestressed.
-
Screw connections must be secured against unintentional loosening with medium-strength
-
thread locker.
Select the nominal tightening torque depending on the thread and the strength class
-
according to VDI 2230.
➢ Fasten the clamping ring to the drive shaft using the clamping ring screw with a tightening torque
of 2 Nm. The torque holder must not be warped or prestressed.
➢ The Spring metal sheet is corrosion-resistant in industrial atmosphere. Special ambient
conditions / media must be clarified with TR-Electronic.
➢ Improperly mounted or damaged torque supports must not be used.
➢ The assembly instructions for the assembly of the clamping ring must be observed, see chapter:
4.2.1 "Mounting of the clamping ring (general)".
Printed in the Federal Republic of Germany
07/07/2023 TR-ECE-BA-DGB-0175 v00
Components:
1: Measuring system
2: Groove insert
3: Dowel pin
4: Parallel key, according to
Art.-No.-related drawing
5: Machine
6: Drive shaft
 TR-Electronic GmbH 2023, All Rights Reserved
Page 47 of 52