Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Aligning the door panel
17.
17.
Undo the nuts.
18.
Align the door panel vertically by
turning the adjusting screws.
Use a Torx 15 screwdriver (not supplied in the
accessory pack).
20.
19.
Align the door horizontally.
20.
Tighten the nuts.
21.
21.
Undo the screws.
22.
Adjust the depth of the door panel.
Tighten the screws.
18.
17.
19.
20.
22.
21.
23.
23.
Screw the bottom of the door onto the door panel (4 x 15 screws).
24.
Undo the angle bracket screws on
the underside of the door.
Adjust the depth of the panel.
Tighten the screws.
Fit the cover to the outer angle
bracket.
Note
Do not fit a cover to the inner angle
bracket. This is the area where the
soft stop mechanism is located.
Important
Align external door panels so that
there is a gap of approx. 2 mm be-
tween the door panel and the body
of the unit.
This will ensure that the door seal
closes properly.
25.
Schließdämpfer auseinanderziehen, auf
den Kugelbolzen drücken und einrasten.
GB
24.
25.
79
Werbung
Inhaltsverzeichnis
