Operation; Cleaning And Maintenance - Junker JD69SE52 Gebrauchs- Und Montageanleitung

Operation

These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
Note: Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel
Erläuterung
Fan on/off
#
- Reduce the fan settings/fan run-on time/interval ventila-
tion
+ Increase the fan settings/intensive setting 1, 2
Light on/off/dimming
A
Setting the fan
Switching on the appliance
Press the button.
#
■
The fan starts at setting
Press the + or - button to change the fan strength.
■
Switching off
Press the button.
#

Cleaning and maintenance

:
Risk of burns!
The appliance will become hot during operation, especially
near the bulbs. Allow the appliance to cool down before
cleaning.
:
Risk of electric shock!
Penetrating moisture may result in an electric shock. Clean the
appliance using a damp cloth only. Before cleaning, pull out the
mains plug or switch off the circuit breaker in the fuse box.
:
Risk of electric shock!
Penetrating moisture may cause an electric shock. Do not use
any high-pressure cleaners or steam cleaners.
:
Risk of injury!
Components inside the appliance may have sharp edges. Wear
protective gloves.
All manuals and user guides at all-guides.com
.
ƒ
Intensive setting
You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
Press the + button when the fan is at setting
The intensive setting ˜‚ is activated. Pressing the + button
again activates the intensive setting
After approx. six minutes, the electronics automatically reduce
the fan to a lower setting . If you want to end the intensive
setting before the preset time expires, press the - button until
the required fan setting is reached.
Fan run-on time
Press the - button until appears.
–
After approx. ten minutes, the fan switches off automatically.
Lighting
The lighting can be switched on and off independently of the
fan.
Press the button.
A
Setting the brightness
Press and hold the button until the desired brightness is
A
reached.
Audible signal
Switching on the acoustic signal
When the fan is switched off, press the
time for approx. three seconds. An acknowledgement signal
sounds.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
Cleaning agents
Observe the information in the table to ensure that the different
surfaces are not damaged by using the wrong type of cleaning
agent. Do not use
harsh or abrasive cleaning agents,
■
cleaning agents with a high concentration of alcohol,
■
hard scouring pads or sponges,
■
high-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the cleaning
agents.
.
„
˜ƒ .
# and + at the same
17