Connections And Functions; Power Supply; Installation - Abus TVIP48511 Installationsanleitung

3. Connections and functions

3.1 Power supply

ATTENTION!
Before you begin the installation, make sure that the supply voltage and the nominal
voltage of the camera match.

3.2 Installation

First remove the dome by loosening the fixing
screws. To do this, use the tool provided
The base plate can then be attached to the
ceiling or wall using the 3 mounting holes,
dowels and screws. Make sure the dowels
are tight.
Carefully loosen the fixing screws on the
camera module. Align the camera module
according to your requirements.
A: Pan (0° – 355°)
B: Tilt (0° – 75°)
C: rotation (0° – 355°)
Tighten the fixing screw again after the
desired alignment of the camera head.
12 VDC, round plug, 5,5 x 2,1 mm
17