Causes And Rectification Of Faults; Disposal Of The Old Device - CASO DESIGN Gastro 3500 Eco Original Bedienungsanleitung

17.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Fault
Device does not react
after switching on
The heating stops and
an acustic signal
sounds.
The heating stops
suddenly during use.
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.

18 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety.
If these were put in the non-recyclable waste or were handled incorrectly, they could be
detrimental to human health and the environment. Therefore, do not put your old device
into the non-recyclable waste under any circumstances.
Utilise the collection point, established in your town, to return and recycle old electric
►
and electronic devices. If necessary, contact your town hall, local refuse collection
service or your dealer for information.
Ensure that your old device is stored safely away from children until it is taken away.
►
Possible Cause
Power plug not plugged in
Fuse switch not switched on
Have you used suitable
cookware?
Is the cookware place at the
centre of the plate?
Have you moved the
cookware during heating?
Is the cookware cooked
empty and temperature is too
high?
Is the air intake/exhast vent
clooged or dirt has
accumulated?
Is the device working more
than 2 hours without further
instruction?
Please note
Please note
To Rectify
Insert plug into mains socket
Switch on fuse switch
Use suitable cookware.
Place the cookware at the
centre of the plate.
Please check the content of
cookware.
Remove the dirt.
Set the functions of device
again or choose the timer
function for operating longer
than 2 hours.
47