Operating The Appliance; Switching On; Power Mode; Temperature Mode - CASO DESIGN Gastro 3500 Eco Original Bedienungsanleitung

Warning
► Ensure that the cookware is properly centred on the hob. It must not be positioned on
the control panel or on the frame.
► In order to prevent overheating do not place any aluminium foil or metal panels on the
appliance surface.
► Do not touch the hot surface of the ceramic hob.
Although the induction cooktop itself does not produce any heat during the cooking
process, the temperature of the cookware does heat up the hob.
► Keep the hob and the underside of the pot clean and dry at all times. If liquid gets
between the base of the pot and the hob, this liquid can vaporise and the resulting
pressure can cause the pot to jump into the air, with a resulting risk of injury.
► Switch the appliance off after use. This avoids unnecessary use of energy, and ensures
your safety.
► If the appliance is unused for extended periods of time, we recommend that the
appliance be unplugged from the mains.

15.4 Operating the Appliance

15.4.1

Switching On

• Plug the power plug into a suitable outlet.
• The temperature of the cooker plate surface displayed: is the temperature of the surface
of the induction cooker lower than 50°C, the display shows „L". When the temperature
of the cooker plate surface is over 50 °C, it is displaying „H". An acoustic signal sounds.
Now the device is in standby mode.
• Place a suitable cooking pot with its contents on the centre on the hob (Ø 120 mm - 260
mm).
• Press the ON/Standby button once. When you have done that an acoustic signal
sounds.
► If no further input occurs within 60 seconds of the device switching on, the light in the
display is turned off and the device goes into Standby mode. To restart the device,
press the ON/Standby button once more.
15.4.2

Power Mode

• Chose power mode with function button (2), then you can see 1700 in the display.
• With the +/- buttons you can choose between 10 levels (500W, 800W, 1200W, 1400W,
1700W, 2000W, 2300W, 2700W, 3000W, 3500W). The choosed power is shown in the
display.
15.4.3

Temperature Mode

• Chose temperature mode with function button (2), then you can see 160°C in the
display.
Please note
43