Optional Accessories - Makita CL108FDSAP Betriebsanleitung

Cleaning
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
NOTICE:
Do not blow dust sticking on the
cleaner and filters by air duster. It brings dust into
the housing and causes failure.
After washing filters, dry them thor-
NOTICE:
oughly before use. Insufficiently dried filters may
cause poor suction and shorten the service life of the
motor.
After cleaning filters and sponge filter,
NOTICE:
be sure to re-install them before use. If you use the
cleaner without filters and sponge filter, dust comes
into the motor housing and cause malfunction.
Cleaner body
From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Clean out also the suction opening and filter mounting
area.
► Fig.38
Troubleshooting
Before asking for repairs, check the following points.
Symptom
Weak suction power
Not working
CAUTION:
Do not attempt to repair the cleaner by yourself.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed
by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Extension wand (Straight pipe)
• Nozzle
• Nozzle for carpet
• Shelf brush
Filter
Wash the filter in soapy water when it is clogged with
dust and the cleaner power becomes weak. Dry it out
thoroughly before use.
► Fig.39
Sponge filter
When the sponge filter becomes dirty, clean it as
follows.
1.
2.
3.
you wash it, dry it out thoroughly before use.
4.
and set it in the original position. Make sure that each
bottom edge of the pillar holds down the sponge filter,
and there is no gap between the sponge filter and suc-
tion opening.
► Fig.40: 1. Sponge filter 2. Bottom edge of pillar
Area to be investigated
Is the capsule full of dust?
Is the filter clogged?
Is the battery cartridge exhausted ?
Is the battery cartridge exhausted ?
•
•
•
•
•
•
•
•
•
•
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
13 ENGLISH
Remove the filter.
Pull out the sponge filter from between the pillars.
Clean the sponge filter by tapping or washing. If
Insert the sponge filter from between the pillars
Empty the capsule of dust.
Clean or wash the filter.
Charge the battery cartridge.
Charge the battery cartridge.
Corner nozzle
Seat nozzle
Free nozzle
Crevice nozzle
Round brush
Flexible hose
Filter
Prefilter
High performance filter
Makita genuine battery and charger
Fixing method