Water Softener Unit - Haier XI6C3D0FB Bedienungsanleitung

WATER SOFTENER UNIT

Depending on the source of the supply, water
contains varying amounts of limestone and
minerals which are deposited on the dishes
leaving whitish stains and marks. The higher the
level of these minerals present in the water, the
harder the water is. The dishwasher is fitted with
a water softener unit which, through the use of
special regenerating salt, supplies softened
water for washing the dishes. The degree of
hardness of your water can be obtained from
your water supply company.
REGULATING THE WATER SOFTENER
The water softener can treat water with a
hardness level of up to 90 °fH (French grading) or
50 °dH (German grading) through 8 settings. The
settings are listed in the table below, with the
relative mains water to be treated.
Water hardness
0 0-5
1 6-10
2 11-20
3 21-30 12-16
4* 31-40 17-22
5 41-50 23-27
6 51-60 28-33
7 61-90 34-50
* The softener unit is set in the factory at level 4
(S4) as this satisfies the requirements of the majority
of users.
0-3 NO
4-6 YES
7-11 YES
YES
YES
YES
YES
YES
Regulate the setting of your water softener unit
according to the degree of hardness of your
water, as follows:
The dishwasher must ALWAYS be off before
start of this procedure.
1. Turn on the dishwasher by pressing the
"ON/OFF" button for about 5 secs.
2. Hold the "PROGRAMME SELECTION" and
"ON/OFF" buttons down for about 5 secs.
3. The message "SETUP" will appear on the
display and the indicator lights of the "OPEN
DOOR/EXPRESS"
buttons will be on.
4. Press the "PROGRAMME SELECTION"
button until you select "SOFTENER S4"
(S4 factory level).
5. Parameter adjustment is performed by
pressing the "OPEN DOOR/EXPRESS"
(S7  S0) and "EXTRA DRY" (S0  S7)
buttons to increase or decrease the
previously set level.
6. Switch off the dishwasher by pressing the
"ON/OFF" button to confirm the new setting.
To change the water softener setting again,
follow the same procedure.
WARNING
S0
If you cannot complete the procedure, turn
S1
the dishwasher off by pressing the "ON/OFF"
button and start the procedure again from the
S2
beginning (STEP 1).
S3
S4
S5
S6
S7
EN 109
and "EXTRA DRY"