TR-Electronic AD 582 Serie Gesamt-Bedienungsanleitung Seite 303

Safety Program Creation - Configuration Example

In order to set the measuring system properties, you must select the measuring
system by double-clicking with the left mouse button in the Network view of the
work area. This opens the Device view of the work area with the measuring
system. Below the Device
displayed in the inspector window, under Properties -> General.

To define the IP address, go to the directory tree and in the General tab select
the directory PROFINET interface[X1] -> Ethernet addresses. The IP
address and subnet mask can be set in the mask under IP protocol. The IP
address is set by the PG/PC. The device name can be defined in the mask under
PROFINET.
 TR-Electronic GmbH 2016, All Rights Reserved
Page 106 of 159
view
the measuring system properties are
TR-ECE-TI-DGB-0292 v02
Printed in the Federal Republic of Germany
08/06/2021