Omnitronic PEN ONE Bedienungsanleitung Seite 17

No. Element
1 Clip indicator
2 Volume controls
3 Tone controls
4 FX controls
5 Input level switch
6 Mono inputs
7 Stereo input
8 AUX input
9 Bluetooth buttons
10 DSP switch
11 Level control
12 Level control
13 Status indicators
Phase reversal switch
14
15 MIX OUT output
16 Power input
17 Fuse holder
18 Power switch
Function
Lights up when inputs CH 1-4 are overloaded. Lower the level of the
signal sources accordingly.
To mix the signals of the mono inputs CH 1-3 to the master signal.
2-band EQ for tuning the tone of the mono inputs CH 1-3.
Adjusts the intensity of the internal echo effect of the mono inputs CH 1-
3.
The 3-position switch is used to adjust the input level: left position = for
microphones, middle position = for high-impedance instruments, right
position = for audio devices with line output (e.g. CD players).
Channels 1-3 provide balanced mono inputs with combo connectors.
Use standard XLR or 6.3 mm cables to connect microphones, high-
impedance music instruments or line-level devices to these inputs. Then
adjust the input level with the corresponding selector switch.
Unbalanced stereo RCA input for channel 4. Use a standard stereo
RCA cable to connect a line-level device (e.g. CD player) to this input.
3.5 mm jack for connecting portable audio units with line level (e.g. MP3
player) to channel 4.
Press this button to turn on the Bluetooth receiver (status indicator starts
flashing); press this button again to reset the Bluetooth connection.
Two PEN ONE systems can be paired for wireless stereo operation. To
do this, pair the Bluetooth source with the first PA system and press the
TWS button. Then press the PAIR button on the secondary unit. The PA
systems are now paired.
To select various equalizer presets according to your application: FLAT
= frequency response is not affected, DJ = increased presence and
bass, LIVE = low and high frequency boost.
Adjusts the volume for the satellite speakers.
Adjusts the volume for the subwoofer.
CLIP: This indicator lights when the internal power amplifier section is
overloaded. Reduce the volume until the LED does not light anymore, or
only at signal peaks.
POWER: Speaker is powered on.
SIGNAL: Input signal is present.
Allows switching the phase from 0° to 180° when multiple PA systems
are operated in parallel.
XLR jack for routing the mixed signal (mono) to devices with line-level
inputs, e.g. another amplifier system.
Used to plug in the supplied power cord.
Only replace the fuse when the device is disconnected from mains. Only
use fuses of the same rating and power. The correct fuse value is
specified on the rear panel.
Turns power to the PA system on and off.
17 • EN