Handling And Operation; Switching The Insoles On / Off / Selecting The Heat Setting - Crivit CEB 2000 A1 Bedienungsanleitung

Handling and operation

In this section you receive important information for the handling
and operation of the appliance.
Switching the insoles on / off /
selecting the heat setting
♦ Place the trimmed insoles
side down and run the cable upward along the heel.
♦ Attach the battery packs
connect the connector plug
nection sockets
Fig. 1
IMPORTANT
► When wearing low shoes, tuck the excess cable into your
socks. The cable must not drag on the ground while walking!
♦ Press the function switch
The battery pack
the function indicator
♦ By pressing the function switch
can be switched on. The function indicator
♦ To switch the battery pack
once more. The function indicator
NOTE
► For quick warming, it is recommended to initially select the
the heat level II. It can later, if necessary, be turned down to
the lower heating level.
► When the battery pack
tor switches off and the insole
CEB 2000 A1
in your shoes with the printed
using the straps to your shoes and
of the insoles
of the battery pack
to switch the battery pack
switches itself on with the heat level I and
glows green.
once again, the heat level II
off, press the function switch
is discharged, the function indica-
with the con-
(see Figure 1).
glows red.
goes out.
is no longer heated.
GB
on.
49