Herunterladen Inhalt Inhalt Diese Seite drucken

Storage; Troubleshooting Guide - Kärcher MC 130 Classic Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Fuse
Function
F1
Fuel valve
CR* control unit
F2
BODAS control unit, display
F3
Limiter lamp
Interior lighting
F4
Spray pump
F5
Warning flasher system
F6
Rear fog lamp
F7
Left limiter lamps
F8
Right limiter lamps
F9
Windscreen wiper
Differential lock
F10
Radio
High-pressure cleaner
F11
Travel direction indicator
F12
Flashing beacon
F13
Driving pump, indicator
F14
Motor
F15
CR* exhaust gas return valve
F16
CR* air volume sensor
F17
Headlights
F18
Work lights
F19
Cabin ventilation
F20
Seat heater
Mirror heater
You can remedy minor faults using the following overview.
If in any doubt, please contact your authorised Customer Service.
DANGER
Risk of electric shock
Switch off the vehicle before carrying out any care and mainte-
nance work, and remove the key.
Malfunction
Vehicle does not start
Motor running irregularly
Engine is running, but the de-
vice does not drive or just
slowly
Motor does not switch off
(main switch to 0)
A
30
5
10
7.5
15
5
5
5
10
7.5
10
10
7.5
5
5
5
15
15
15
15

Troubleshooting guide

Vehicle malfunctions
Remedy
 Check / charge the battery.
 Switch on the main switch.
 Sit in the driver's seat (seat contact switch is activated).
 Set the driving direction lever to the NEUTRAL position - central position.
 Fill up fuel, bleed the fuel system.
 Check, clean and/or replace the fuel filter.
 Check the fuel connections and lines.
 Contact an authorised Customer Service department.
 Clean/replace the air filter.
 Check, clean and/or replace the fuel filter.
 Fill up fuel, bleed the fuel system.
 Check the fuel connections and lines.
 Contact an authorised Customer Service department.
 Release the parking brake.
 Check the position of the neutral lever.
 Have the oil level of the drive hydraulics checked by Customer Service.
 In the event of freezing temperatures and cold hydraulic oil: Allow the device to warm up for at least
3 minutes.
 Close the fuel cock at the fuel filter.
 Unplug the fuel supply pump.
 In the event of repeated occurrences, contact Customer Service.
Fuse
Function
F21
Cabin accessories
Front connector, attached equipment
F22
Seat compressor
Rear connector, distributor
F23
Start switch (ignition switch)
F24
Windscreen heater
F25
Preheating
F26
BODAS control unit
F31
Main fuse at the engine
* CR = Common Rail motor (MC 130 Advanced plus)
WARNING
Risk of injury and damage
Note the weight of the device.
1. Park the vehicle in a safe, level and dry place, leave the main
switch on.
2. Change the motor oil and the oil filter.
3. If frost is expected, check if there is enough antifreeze in the
coolant.
4. Empty the water container and the pipe system.
5. With a recycling system (option), drain the water out of the
waste container.
6. Switch off at main switch.
7. Clean the inside and outside of the vehicle.
8. Jack up the vehicle if it is in storage for more than one month.
9. Disconnect battery.
Repair work and work on electrical components must only be per-
formed by your authorised Customer Service.
English

Storage

A
15
30
5
30
40
30
70
107

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

Mc 130Mc 130 plusPf-d

Inhaltsverzeichnis