Important Notice - INVENTOR MFVI-09WFI Benutzerhandbuch

56°C Sterilization
The 56°C Sterilization function can only be activated through the mobile application Inventor
Control.
When 56°C Sterilization function is activated, the air conditioner will operate as below:
1st Stage: The air conditioner will start with the Self Clean function in order to remove the dirt.
During the Self Clean function, the evaporator will operate under cooling mode, freezing the
evaporator of the indoor unit, then operate under heating mode to melt the frost and remove the
dust and dirt that has accumulated on the evaporator. The unit will proceed with operation under
fan mode to quickly dry the evaporator. The hydrophilic aluminum coating with small angle (α≈5°)
increases the water drainage efficiency.
2nd Stage: Through smart temperature monitoring and frequency control technology, the unit
will enter the 56°C Sterilization phase, maintaining the evaporator's high temperature for over
30m in order to exterminate possible bacteria and viruses inside the air conditioner.
3rd Stage: The air conditioner will enter a rapid cooling process to enhance the sterilization
performance. The evaporator surface is coated with silver nanoparticles whose anti-bacterial
efficiency is up to 99%.

Important Notice:

The 56°C Sterilization function
lasts approximately 60-80 minutes. Hot air may come out during this function.
l
may result in the changes of room air temperature. This is normal.
l
When outdoor ambient temperature is above 36°C, only the 1st Stage (Self Clean function) will be
activated.
12