Device Description - Beurer IPL 8800 Velvet Skin Pro Gebrauchsanweisung

• beurer Velvet Skin Pro protects your skin
Light-based hair removal is not suitable for naturally dark skin tones or tanned skin. The beurer Vel-
vet Skin Pro features an integrated skin colour sensor that measures the colour of the area of skin to
be treated, meaning that it is only possible to use the device on suitable skin colours. This safety fea-
ture prevents you from treating your skin if it is too dark or too tanned. The light opening of the device
features built-in UV protection, blocking dangerous UV radiation.
• beurer Velvet Skin Pro protects your eyes
To protect the eyes, the beurer Velvet Skin Pro features a built-in skin contact sensor. The sensor
was developed so that no light pulses can be emitted when the device is held in the air. A flash is
only triggered when the skin contact sensor is resting on your skin.

6. Device description

1
2
10
3
4
5
6
6
7
8
1. ON/OFF button – The device is switched on and off by simply pressing the
switches off automatically if it is not used for five minutes. When the device is switched on, all the
lights on the energy level display briefly illuminate, whereupon the device switches to energy level 1.
2. Button for automatic skin tone detection – By pressing the
recommended energy level for your treatment on the relevant area of skin. When this button is
pressed, all energy level selection buttons flash for ten seconds. If the skin contact sensor is in full
contact with the desired treatment area and a light pulse is emitted, the recommended energy level
(depending on the skin tone at the area being treated) is automatically set; the energy level display
illuminates accordingly.
It should be noted that the recommended energy level is only selected if the corresponding button
is pressed, not if the skin tone changes or the treatment area is changed.
3. Energy level selection buttons – The button + (higher energy level) and – (lower energy level) allow
you to choose between six different levels. Select the energy level according to your personal phy-
sical comfort or based on your skin sensitivity test. You can use the button for automatic skin tone
detection to select the optimum energy level for each treatment area.
• By pressing the buttons + or – (after switching on the device), the energy will be increased or lowe-
red respectively by one level. Each additional press changes the energy level between the lowest
(marked with "1") and the highest level (marked with "6").
• A corresponding number of green lights on the energy level display illuminate depending on the
selected energy level.
9
12
11
31
1. Flashing light
2. Light opening
3. Trigger button (the "Auto Flash" mode is
applied after 3 flashes have been triggered in
succession).
4. Energy level display
5. Battery level display
6. Energy level selection buttons
7. Button for automatic skin tone detection
8. ON/OFF - button
9. Indicator lamp
10. Skin tone and skin contact sensor
11. Charging socket
12. Precision attachment
button, you can establish the
button. The device