Device Description; Initial Use - Beurer SI 40 Gebrauchsanweisung

Prior to initial use
Important
• Remove all packaging material before using
the device.
• Protect the device against dust, dirt and hu-
midity and never cover the device while it is in
use.
• Do not operate the device in a very dusty area.
• Switch the device off immediately if it is faulty
or not working properly.
• The manufacturer is not liable for damage re-
sulting from improper or incorrect use.
Repairs
Note
• Under no circumstances should you open or
repair the device yourself, as faultless function-
ality can no longer be guaranteed thereafter.
Failure to comply with this instruction will void
the warranty.
• The device is maintenance-free.
• For repairs, please contact Customer Services
or an authorised retailer.

5. DEVICE DESCRIPTION

The associated drawings are shown on page 3.
Aroma mask
1
Variable steam regulator
2
Cover
3
Lid
4
Water heater tank
5
ON/OFF switch
6
Mains connector cable
7
Return container
8
Aroma container
9
Suction tube
10
Nozzle
11
Facial sauna mask
12

6. INITIAL USE

Note
Follow the instructions in the Chapter "Cleaning
and disinfection" before using the device for the
first time or if it has not been used for an extended
period.
1. Remove the device from the packaging. Ensure
that there is a mains socket close to the set-
up area.
2. P
lace the device on a firm, even surface and pull
the cover up and off by pressing the button above
the aroma container/return container.
3. R
emove the sticker with the warning notice from
Twist the lid anti-clockwise. Observe
the cover.
the marking on the lid when you do this. Re-
move the lid.
B
4. Fill the water heater tank with approx. 25 ml of
water (do not fill the water heater tank above
the "MAX" marking). Always use water to fill the
water heater tank and never use any other liq-
uids.
C
5. Refit the lid and close it tightly by turning it
clockwise. Observe the marking on the lid when
you do this.
6. Replace the cover from above.
7. Pull out the aroma container/return container.
Fill the aroma container with the liquid that you
want to atomise (e.g. salt-water solution). Never
fill the aroma container above the "MAX" mark-
ing (60ml).
D
8. Re-insert the aroma container/return container
into the device. Make sure that the suction tube
touches the bottom of the aroma contai
15
A
ner.
E