Filling The Clean-Water Tank - Numatic ET 4045 Bedienerhandbuch

Filling the clean-water tank

The TT / ET Range are all equipped with a 40 litre clean-water tank allowing large areas to be cleaning in a single fill.
Fig.12
The clear Dump hose at the rear of the machine can be used to see the level of the clean water.
Note:
Great care must be taken to ensure that contaminants (leaves,hair, dirt, etc) are not allowed to enter the
clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean and free from debris.
Clean water level
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturer's specification.
For further guidance on hazardous substances refer to health and safety instructions online.
Visit http://www.hse.gov.uk/
!
WHEN HANDLING AND MIXING CHEMICALS.
Always ensure that chemical manufacturer's safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
!
Important
Do not operate machine unless the Operator Manual has been read and fully understood.
Clean-water tap
To fill the clean-water tank, use the 1 meter
FLEXI - FILL pipe from either a tap or hose pipe
(Fig.12).
The large cap can also be unscrewed for filling
from a bucket or suitable
container.
Fill the clean-water tank to a maximum of 40 litres,
including cleaning chemicals if required.
Follow chemical manufacturing guide lines.
The water level in the clean-water tank can be seen using the clean-water clear
dump hose fitted to the rear of the machine.
The clean-water bottom tank holds 40 litres.
for UK information.
Turn on the clean-water tap
22
Machine Set-Up
Off
!
!
On