Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.2
Saving the Data to a USB Memory Stick
Remove the protective cap (see Fig. 10.2, Item 2) from
the
USB A output (see Fig. 10.2, Item 1) on the bottom of
the device (bayonet catch).
Connect a standard memory stick.
Go to display 6 (see Fig. 10.3)
(see also chapter
Selection of the
Start the saving process using
The following data is saved on the memory stick and can be visualized via an Excel
template:
• 5000 individual tapping processes
• 250 error messages
• Consumption data (water consumption, chemical consumption, lifetimes)
• System configuration
The operating data can also be saved from the programming level.
NOTE
See chapter
10.3
Deletion of the Saved Consumption Data, Operating Data and Error Messages
The complete consumption data memory is deleted as follows:
Go to the programming level.
(Also refer to chapter
Entry to the delete functions
Select
Now start the delete process by means of
Exit programming mode again.
Then following data is deleted:
•
NOTE
•
•
417102242_DG_3
10.1
"Display of Consumption").
icon using
8.2
"Programming Structure".
8.2
"Programming Structure" and
Fig. 10.4
Deleting the consumption data memory
and activate it by pressing
Individual tapping processes
Error messages
Consumption data (water consumption, chemical consumption, lifetimes)
or
.
.
8.4.1
.
.
- 90 -
Fig. 10.2
USB A output
Fig. 10.3
Display [6]
"Operation Handling").
Rev.: 02-05.2014
Werbung
Inhaltsverzeichnis
