Care And Cleaning - Kenwood KM242 Bedienungsanleitungen

to use the small feed tube
G First put the large pusher inside the feed tube.
to use the large feed tube
G Use both pushers together.
7 Put the food into the feed tube.
8 Switch on and push down evenly with the pusher - never put your
fingers in the feed tube. We recommend a medium speed for
processing soft foods such as cucumber and a medium/high speed for
processing firmer foods such as carrots and hard cheese.
9 Switch off and unplug.
10 Remove the attachment.
11 Refit the medium speed outlet cover after use.
hints
Use fresh ingredients.
G
Don't cut food up too small. Fill the width of the large feed tube fairly full.
G
This prevents the food from slipping sideways during processing.
Alternatively, use the small feed tube.
When slicing or shredding: food placed upright comes out shorter than food
G
placed horizontally.
After using a cutting disc there will always be a small amount of waste on
G
the disc or in the food.

care and cleaning

Always switch off and unplug before removing the attachment from the
G
kitchen machine.
Dismantle the attachment fully before cleaning.
G
bowl, lid and attachments
Wash by hand then dry. Take care as the blades and cutting discs are sharp.
G
Alternatively they can be washed on the top rack of your dishwasher. A short
G
low temperature programme is recommended.
After use store the knife blade in the processor bowl.
citrus juicer
Note:
This attachment can only be used in conjunction with the food processor
AT284.
Use the citrus juicer to squeeze the juice from citrus fruits, eg oranges,
lemons, limes, grapefruits.
key
cone
sieve
to use your citrus juicer
1 Remove the medium speed outlet cover by lifting off
2 Place the drive shaft onto the outlet.
3 Fit the bowl over the drive shaft with the handle above the on/off and speed
switch and turn clockwise until it locks into position.
4 Fit the sieve into the bowl ensuring that the lug on the rim locks into the
corresponding slot in the bowl handle
G The attachment will not operate if it is incorrectly assembled
or incorrectly fitted to the kitchen machine or if the high
speed outlet cover is not fitted.
5 Place the cone over the drive shaft turning until it drops all the way down.
6 Cut the fruit in half. Switch to speed 3 and press the fruit onto the cone.
Note
Empty the bowl regularly and never let the juice reach the underside of the
sieve.
7 Switch off and unplug.
8 Lift off the cone. Unlock and remove the sieve.
9 Unlock the bowl and pour off the juice.
care and cleaning
G Always switch off and unplug before removing the attachment from the
kitchen machine.
G Wash the cone, sieve and bowl by hand, then dry thoroughly. Alternatively
wash in the dishwasher (top rack only).
.
.
Centrifugal Juicer AT285
Use the centrifugal juicer for extracting juice from fruit and vegetables.
safety
Do not use the juicer if the filter is damaged.
G
The cutting blades on the base of the filter are very sharp, take care when
G
handling and cleaning the filter.
Only use the pusher supplied. Never put your fingers in the feed tube.
G
Unplug before unblocking the feed tube.
Before removing the lid, switch off and wait for the filter to stop.
G
This machine will be damaged and may cause injury if the interlock
G
mechanism is subjected to excessive force.
Do not use the lid to operate the attachment, always use the on/off speed
G
control.
Should excessive vibration occur when using this attachment, either adjust
G
the speed or stop the machine, unplug and clear any blockage.
key
pusher
lid
lid interlock tab
filter
pulp container
juice outlet
pulp container release lever
base unit
beaker
beaker holder
to use your centrifugal juicer
preparing food
Remove stones (plums, peaches, cherries etc).
G
Remove tough skins (melons, pineapples, cucumbers, potatoes etc).
G
Soft-skinned and other foods just need washing (apples, pears, carrots,
G
radishes, lettuce, cabbage, parsley, spinach, grapes, strawberries, celery
etc).
Citrus peel - Peel and remove the white pith, otherwise the juice may be
G
bitter. For best results we recommend using the citrus juice attachment
which is available separately.
assembly and use
1 Remove high speed outlet cover before assembling unit
2 Place the pulp container onto the base unit and turn clockwise until it locks
into position. When correctly fitted the spout should be located over the
pulp container release lever.
3 Fit the filter and push firmly into position.
4 Fit the lid into the pulp container with the interlock tab next to the arm of the
base unit. Then turn clockwise until the interlock tab on the lid fits into the
groove in the upright arm of the base unit. When correctly fitted the
markings should align .
5 Place the beaker holder onto the underside of the attachment – the arrow
on the beaker holder should be pointing upwards and aligned with the spout
and pulp container release lever.
6 Whilst holding the beaker holder in place, fit the attachment to the mixer by
placing the spout over the corner of the high speed outlet and then turn
clockwise to lock into position.
7 Move the beaker holder towards the back of the mixer and then fit the
beaker. Swivel the holder into position so that the beaker is located
underneath the juice outlet
8 Cut the food to fit the feed tube.
The attachment will not operate if it is incorrectly assembled
G
or incorrectly fitted to the kitchen machine or if the medium
speed outlet cover is not fitted.
9 Switch to speed 3, then place the food into the feed tube. Push the food
down evenly with the pusher - never put your fingers in the feed
tube.
10 Switch off and unplug.
11 Refit the high speed outlet cover after use.
7
(if supplied)
.
.