Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Batteries
Please observe the following warning notes
when handling batteries:
Observe the directions on the bat-
tery, in the instructions for use and
in the vehicle operating instructions
Wear eye protection
Keep children away from acid and
batteries
Danger of explosion
Fire, sparks, naked flames and
smoking must be strictly avoided
Danger of chemical burns
First aid
Warning note
Disposal
Do not throw the battery into the
regular waste
DANGER
Risk of explosion. Do not place tools or the
like on the battery, i.e. on the terminal poles
and cell connectors.
Risk of injury. Ensure that wounds never
come into contact with lead. Always clean
your hands after having worked with batter-
ies.
Recommended batteries, B 60
Order No.
Description
6.654-141.0
105 Ah - mainte-
1)
nance-free
6.654-242.0
170 Ah - mainte-
2)
nance-free
6.654-124.0
180 Ah - mainte-
3)
nance-free
6.654-086.0
180 Ah, - low mainte-
4)
nance
* Appliance requires 2 batteries
** Appliance requires 4 batteries
Complete set (24 V/105 Ah) incl. connect-
1)
ing cable, order no. 4.035-373.0
Complete set (24 V/170 Ah) incl. connect-
2)
ing cable, order no. 4.035-388.0
Complete set (24 V/180 Ah) incl. connect-
3)
ing cable, order no. 4.035-387.0
Complete set (24 V/180 Ah) incl. connect-
4)
ing cable, order no. 4.035-440.0
Insert batteries and connect
Push the appliance forward about 2 m
so that the steering rollers point toward
the rear.
Lower the cleaning head.
Empty the fresh and waste water tank.
Loosen the tank lock and tilt the tank
upwards.
Place the batteries in the tray close to
each other towards the cleaning head
and fasten them to the floor using the
included holding blocks.
CAUTION
When the batteries are installed and re-
moved, the stability of the appliance can be
compromised; ensure a safe stance.
Connect the connection cable to the
free battery poles (+) and (-).
Connect pole using the enclosed con-
necting cable.
ATTENTION
Pay attention to correct poles.
Installation sketch for 2 batteries
12 V*
Installation sketch for 4 batteries
Swivel the water reservoir all the way
6 V**
down, check the lock.
Note:
6 V**
Charge the batteries before commissioning
the appliance.
6 V**
See also "Charging the batteries".
EN
CAUTION
R isk of damage due to tipping appliance;
remove batteries only if the appliance is
equipped with a cleaning head.
Remove the Intelligent Key.
Push the appliance forward about 2 m
so that the steering rollers point toward
the rear.
Lower the cleaning head.
Empty the fresh and waste water tank.
Loosen the tank lock and tilt the tank
upwards.
Clamp off the minus pole of the battery.
Clamp off the remaining cables from the
battery.
Remove the support blocks or the foam
pieces.
CAUTION
When the batteries are installed and re-
moved, the stability of the appliance can be
compromised; ensure a safe stance.
Remove the batteries.
Dispose of the used batteries according
to the local provisions.
To ensure a reliable operation of the appli-
ance maintenance contracts can be con-
cluded with the competent Kärcher sales
office.
In case of danger of frost:
Empty the fresh and waste water tank.
Store the appliance in a frost-protected
room.
DANGER
Risk of injury! Before working on the appli-
ance, remove the Intelligent Key and the
mains plug of the charger.
Drain and dispose of the dirt water and
the residual fresh water.
8
-
Removing the batteries
Maintenance contract
Frost protection
Faults
21
Werbung
Inhaltsverzeichnis
