Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the EUROLITE LED TMH-3 Spot starts running. During the
Reset, the motors are trimmed and the device is ready for use afterwards.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.
Stand Alone operation
In the Stand Alone mode, the LED TMH-3 Spot can be used without controller.
Disconnect the LED TMH-3 Spot from the controller and call the internal program. Please refer to the
instructions under Control Board.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Set the desired Master-mode - „Automatic program mode" or „Sound controlled mode" - for the master-
device. Set the DMX address 1 for all slave-devices.
Control Board
The Control Board offers several features: you can simply set the starting address, run the pre-programmed
program or make a reset.
UP
MODE/ESC
The main menu is accessed by pressing the Mode/Esc-
button. Browse through the submenu by pressing Up or
Down. Press the Enter-button in order to select the desired
menu. You can change the selection by pressing Up or
Down. Confirm every selection by pressing the Enter-
button. You can leave every mode by pressing the
Mode/Esc-button. The functions provided are described in
the following sections.
DOWN
ENTER
25/30
00048782.DOC, Version 1.1
Werbung
Inhaltsverzeichnis
