Vacuum Cleaner Preparation; Use Of Vacuum Cleaner; Removing The Dust Container And Filters - eta 0517 Bedienungsanleitung

EN
III. VACUUM CLEANER PREPARATION
Remove all packing material, take out the vacuum cleaner and the accessories.
Remove all possible adhesion foils, stick-on labels or paper from the appliance.
VACUUM CLEANER ASSEMBLY
When assembling the vacuum cleaner, follow the procedure indicated in Fig. 1.
Choose appropriate accessories as required (C1 - C9) (Fig. 8). The telescopic suction tube
C11 can be set to an optimum length to suit the user´s height.
IV. USE OF VACUUM CLEANER
Before use, unwind (by pulling) the power cable A8 from the vacuum cleaner to a required
length and plug the vacuum cleaner to the mains.
CONTROL (ETA0517, ETA1517, ETA2517)
A1 button - vacuum cleaner ON/OFF switch
A2 button - when pressed and held, the unwound part of the power cable rewinds
back inside
Knob A3 - by turning it to the right, you increase the suction power
- by turning it to the left, you reduce the suction power
CONTROL (ETA4517)
Control panel D + handle with remote control E (Fig. 5, 6)
D1 button
E1 button
D2/E2 button
D3/E3 button
A2 button
– Adjust the suction power as you feel it necessary based on the surface being cleaned.
– Before you use the remote control, fit 2 pcs of AAA batteries in it (Fig. 6). Batteries
are included in the box.
– If you wish to use the remote control, you must switch ON the vacuum cleaner first by
pressing the button A1.
– With the remote control you can switch the vacuum cleaner ON or OFF and regulate
the suction power. The light indicator E4 comes on every time the remote control
transmits a signal (when a button is pressed).
V. REMOVING THE DUST CONTAINER AND FILTERS
– Maximum suction performance can be achieved when the filters are clean and the
dustbag is empty.
– Every time you empty the dust container, we recommend that you also clean the filters.
– When you are vacuuming very fine dust, the filter pores might get clogged. This
reduces the air flow and the suction performance deteriorates. In such a case, the
filters need to be cleaned even though the container is not full yet.
- vacuum cleaner ON/OFF switch
- vacuum cleaner ON/OFF switch (the button only works in
standby mode)
- when pressed, the suction power increases
- when pressed, the suction power decreases
- when pressed and held, the unwound part of the power cable
rewinds back inside
Notes
Caution
26 / 50