Power Cable - eta BARELO Bedienungsanleitung

GB
– The working position of the cleaner is vertical (i.e. upright) and it is not allowed to put the
cleaner up, tilt it or turn it over during wet cleaning as water may leak from the tank!
– When using the cleaner to clean smooth flooring take special care when walking in order
to avoid injury by slipping.
– When using the cleaner for wet cleaning, the float may block the suction opening when the
cleaner runs over an obstacle (such as the threshold). If so, turn the cleaner off and on
again or empty the waste water tank.
– Before removing solid dirt using the dust bag, dry vacuum cleaner interior, suction
hose and pipes. Immediately before changing from wet to dry cleaning, the accessories
should be dried with air flow for minimum 10 minutes. The dust bag can only be inserted
after cleaning and drying of the suction mechanism.
– The appliance must not be used in damp or wet environment and in any environment with
the danger of fire or explosion.
– The vacuum cleaner is not suitable for vacuuming substances that can harm human health.
– Do not vacuum sharp objects (e.g. glass, shatter), hot, flammable, explosive items
(e.g. ash, hot cigarette butts, gasoline, thinners and aerosol vapours) or greases
(e.g. fats, oils), caustic agents (e.g. acids, solvents).
– Do not use the vacuum cleaner to vacuum dirt produced during/after construction such as
plasterboard dust, fine sand, cement, dust from construction, parts of plaster etc.
– WARNING: There is a risk of injury in case of incorrect use (not in accordance with the
manual) of the appliance.
ACCESSORIES AND ASSEMBLY OF THE APPLIANCE:
– Do not put the suction nozzle or the tube end or accessories close to eyes and ears and do
not insert them into body orifices!

POWER CABLE:

– Check whether the data on the type label corresponds with the voltage in your socket.
The power cord plug may only be connected to the electrical socket complying with the
applicable standards.
If the power cord of the appliance is corrupted, it has to be replaced
–
by the manufacturer, its service technician or a similarly qualified
person.
Always disconnect the appliance from power by unplugging
–
the power cord from the electrical socket, if the appliance is left
unattended and before assembly, disassembly or cleaning.
Never use the appliance if the power cord or power plug are
–
damaged, if the appliance is not correctly operating or if it has fallen
on the floor and been damaged, or if it has fallen into water.
– Do not unplug the power plug by pulling the power cord or the vacuum cleaner unit.
– When winding the cord, hold the plug to prevent lashing of the cord around and to prevent
possible injury.
– The power cord must not be damaged with sharp or hot objects, open fire, it must
not be sunk into water or bent over sharp edges.
For trouble-free operation of the vacuum cleaner, please use the
tested dust filters and micro-filters recommended by the producer.
20 / 42