Operation; Checks By The Operator; Refilling With Cleaning Fluid; Operating The Easyclean 200 E - Mettler Toledo INGOLD EasyClean 200 e Bedienungsanleitung

EasyClean 200 e
5
5.1
a
5.2
a
5.3
h
a
h
© 05 / 2023 METTLER TOLEDO
Printed in China

Operation

Checks by the operator

When switching the device on, every day and when a new shift starts, check whether the supply
of: compressed air, rinsing water and electrical power is guaranteed, that the containers are
full of cleaning solution.
CAUTION
The retractable housing may only be moved into the measuring position when the electrode
has been installed, as otherwise process medium might leak from the
retractable housing.

Refilling with cleaning fluid

CAUTION
Wear the prescribed protective clothing (protective glasses, gloves, etc.).
The flow meter (optional accessory) indicates whether a liquid is being delivered. If no liquid
can be detected during a delivery process, the EasyClean generates a "Level" alarm. In this event
the following possibilities arise:
– no water flow
– detergent cannot be drawn in (the container must not necessarily be empty –
see section 6.2 "Corrective action").

Operating the EasyClean 200 e

NOTE!
In the "SERVICE" position the "HOLD" contact in the EasyClean is always closed.
CAUTION
Do not remove the sensor from the retractable housing unless the "SERVICE" message
appears in the display of the PLC. Additionally check the position of the housing visually.
NOTE!
During a process, signals from the transmitter are ignored.
Signals emitted during a process are not stored.
Only one process may be performed at a time.
The position of the housing before a process is identical to its position after a process.
This cycle runs for as long as the button is pressed down. No timer is activated.
33
EasyClean 200 e
30 404 676 H