Mettler Toledo INGOLD EasyClean 200 e Bedienungsanleitung Seite 22

22
h
EasyClean 200 e
30 404 676 H
Connections to the housing floor valve unit
1 Control cable, control M 16 (premounted)
2 Flow sensor duct M 12 (optional)
3 Compressed air input (∅ 6/4 mm hose)
4 Water input G / " female (adapter for "NPT & male")
4
1
Detergent solution input (PTFE hose, ∅ 6/4 mm, white)
6
7 Compressed air housing "Service" output (LDPE hose, ∅ 6/4 mm, black)
8 Medium output (PTFE hose, ∅ 6/4 mm, white)
Compressed air housing "MEASURE" output (LDPE hose, ∅ 6/4 mm, black)
10
NOTE!
For purposes of efficiency, a valve is installed for water and compressed air from the building
close to the EasyClean 200 e. This facilitates maintenance work and increases working safety
during fitting and dismantling of the device.
The compressed air feed must be at least 4 bar. The control air must be filtered and free of
water and oil.
Please observe the local regulations for pneumatic and water installations.
Connections to the immersion housing
For the installation of the retractable housing, please refer to the corresponding instruction
manual for the housing.
Electrical connections
The EasyClean 200 e is designed for the METTLER TOLEDO transmitter as described in section
1.3. For the correct installation to other transmitters, please refer to the relevant manual.
EasyClean 200 e
© 05 / 2023 METTLER TOLEDO
Printed in China