Operation; Switching On And Off; Device Adjustments; Practical Tips - Parkside PUB 500 B1 Originalbetriebsanleitung

2. Insert the additional handle (14) into
the holder beneath the handle (1).
3. Screw the additional handle (14) tightly
using the grip screw (6). There are se-
veral possible latching positions.

Operation

Caution, risk of Injury!
Always check whether the
device functions correctly be-
fore using it.
Always wear eye protection
when operating the device.
Always unplug the device be-
fore working on it. There is a
risk of injury.
Observe the noise protection and
other local regulations. .

Switching ON and OFF

1. Plug the tool into the mains.
2. To turn on, use your thumb to actuate
the switch lock (4), then press the On/
Off switch (2). Release the switch lock.
3. To turn off, release the On/Off switch (2).
There is no continuous operation mode.
The brush will keep rotating for a
few seconds after the device has
been switched off. Keep the brush
away from hands and feet.
Do not try to lock the on/off
switch in place. Do not use the
device if the switch is damaged.
A damaged switch may cause
an injury risk due to the motor
not being switched off after
releasing the on/off switch.
GB

Device adjustments

Length adjustment:
The telescopic arm enables you to adjust the
device to your individual height.
Unfasten the screw sleeve for length adjust-
ment (7). Adjust the telescopic arm (8) to
the desired length and re-fasten the screw
sleeve for length adjustment (7).
Adjusting the splash guard:
You can adjust the splash guard (9) by sli-
ding it backwards and forwards.
Setting the rotation speed:
There are six possible rotation speed set-
tings on the speed regulator (15).

Practical tips

Caution,
risk of Injury!
• Always inspect the brush before starting
the device. Never use damaged brushes.
Replace any damaged or worn brush.
• Use original brushes only.
• Never operate the device in rain or on
wet ground. Operating the device in
rain or on wet ground can cause an
electric shock.
• Always move across the slope when
working on hills.
• Avoid any contact with fi xed obstacles
(rocks, walls, picket fences, etc.) in or-
der to prevent damages to the device.
• Switch off the device during breaks or
when transporting it and wait until the
brush has completely stopped rotating.
Using the device:
When working with metal and ny-
lon brushes, never move the brush
IE NI CY
11