Inhaltsverzeichnis
Werbung
Before the first Use
Unpack the convector heater and check the unit for any damage in transit.
Dispose of packaging materials or store it out of reach of children. Plastic bags
etc. may become a deadly toy for children. Before first use, clean the housing as
described in chapter "Cleaning".
Assembling
For transport protection, the stand supports (3) of the
convector heater are not attached.
Fasten the stand supports on the base plate. Use the small
screws included in the package. The unit has to be placed
on a firm, level ground.
Operation
The heater is equipped with a turn knob (4) with which you can set the heater to
two power settings either with or without the ventilator.
To activate the heater with the ventilator select the temperature settings with a
ventilator symbol next to it.
Temperature Control/Thermostat
Turn the thermostat switch (5) clockwise to the highest setting. As soon as the
desired room temperature has been reached, turn the thermostat switch
counter clockwise until you notice a click sound. This way the heater will be
switched on and off automatically. The desired room temperature is
maintained.
Turn the thermostat switch clockwise in order to reach a higher room
temperature. Turn the thermostat switch counter clockwise, in order to
decrease heating power. The heater will switch on and off at a lower room
temperature.
Overheat Protection
To prevent overheating, the built-in thermal overheating protection switches off
the heater. Overheating may occur if the unit is covered while operation, if the
convector heater is placed wrongly, the grille inside is dirty or if any objects are
obstructing the air flow.
Turn off the heater and pull the power plug. Remove the causes and clean the
1.
convector heater.
First, allow the heater to cool down for at least 20 minutes. Then insert the
2.
power plug again into a grounded wall socket. The convector heater is ready
Operation
11
Werbung
Inhaltsverzeichnis
