Choice Of Gear; Checking The Battery Charge Level; Working Instructions; Securing The Workpiece - Parkside PAAP 12 B2 Originalbetriebsanleitung

GB IE
1. Place the rechargeable battery (5) into
the device.
2. To release, press the start lock (8) on
the side with the opened lock into the
device.
3. Press the on/off switch (7) to start the
device.
4. To switch off, release the on/off button
(7). The start lock (8) automatically se-
cures the device from being turned on
again unintentionally.

Choice of gear

Slide the gear selector (3) to 1 or 2,
corresponding to a low or high torque
selection.
A gear change may only be per-
formed in standstill mode!
Checking the battery
charge level
The battery charge indicator (4) signalises
the state of charge of the battery (5) by
illuminating the corresponding LED lights
when the device is in operation.
To see the charge level, keep the on/off
switch (7) depressed.
red-yellow-green => Battery fully charged
red and yellow
red
28
=> Battery half charged
=> Battery needs
to be charged

Working instructions

Do not use any accessories that are
not recommended by PARKSIDE. This
can result in electric shock or fire.

Securing the workpiece

Fasten and secure the workpiece by means
of jigs, a vice or with another method on
a stable surface. If you hold the workpiece
only with your hand, foot or against your
own body, it will stay instable and this can
lead to a loss of control..

Touching up

For touch-up work, choose the sandpaper
(12).
If required, polish the workpiece being ma-
chined after the touch-up.

Polishing

• Please refer to the information from the
polishing agent manufacturer.
• Test the polishing pads (10/11), imitati-
on fur (13) and polishing agent prior to
use on an inconspicuous area.
• Use the orange polishing pad (10) for
pre-polishing, the black polishing pad
(11) for post-polishing, and the imitati-
on fur (13) for high-gloss polishing and
to remove excess polishing agent.
• Put some polishing agent onto the poli-
shing pad (10/11). Put polishing agent
onto an area slightly smaller than the
area you wish to polish on the workpiece
and spread the polishing agent manually.
• Move the device evenly over the sur-
face to be polished.
• Do not apply any pressure. Pressing
onto the workpiece does not improve
the work result.