Assembly; Assembling; Disassembling The Polishing Disc; Attaching/Changing The Attachments - Parkside PAAP 12 B2 Originalbetriebsanleitung

Do not use any paints contai-
ning lead or materials contai-
ning asbestos.
Observe the safety infor-
mation and notes on char-
ging and proper use as
shown in the instruction
manual for your battery
and charger from the Park-
side X 12 V Team series. A
detailed description of the
charging process and further
information can be found in
the separate operating inst-
ructions.

Assembly

Remove the battery from the
device if necessary! There is
a risk of injury.

Assembling/

disassembling the
polishing disc
Assembly
1. Keep the spindle stop button (2) de-
pressed.
2. Screw the polishing disc (9) clockwise
into the thread socket (1).
3. Tighten the polishing disc (9) by hand.
Disassembly
1. Keep the spindle stop button (2) de-
pressed.
2. Screw the polishing disc (9) anti-clockwi-
se out of the thread socket (1).
Attaching/changing the
attachments
The attachments are fastened using a Velc-
ro strip to the polishing disc.
Attaching
1. Place the desired attachment
(10/11/12/13) centrally onto the poli-
shing disc (9).
2. Firmly press the attachment onto the
polishing disc.
Removing/changing
1. Pull the attachment sideways from the
polishing disc (9).
Attaching the additional
handle
1. Screw the additional handle (14) onto
the left or right of the device head.
2. Tighten the additional handle (14) by
hand.

Operation

Removing/inserting the
Battery
1. To remove the battery (5) from the ap-
pliance, press the release button (6) on
the battery and pull out the battery.
2. To insert the battery (5), place it on the
guide track and push it into the appli-
ance. It will audibly snap in.

Switching on/off

By using the on/off switch (7) you can
progressively control the speed. The longer
you push the on-off button, the higher the
speed.
GB IE
27