Using The Blender Attachment; Using The Juice Extractor - Westfalia 68 20 70 Bedienungsanleitung

Using the Blender Attachment

1. Attach the chopping blade (H) to the bottom of the pitcher (A),
screw it on clockwise until it is secured.
2. Place the pitcher on the main base.
3. Add ingredients and put lid on pitcher. Do not fill higher than
the 500 ml mark. Use the clear cap (B) inside the lid.
4. Plug in the power cord into a wall outlet. Only touch the plug
with dry hands. Once secure, press and, if desired, twist entire
attachment to lock on. Blend until the desired consistency is
reached. When blending hot ingredients, be very careful as
some hot contents may be splashed out in some cases.
5. To prevent the liquid from spilling during blending please keep
the cut-outs of lid and spout out of alignment.
6. Before you pour out the liquid, please release the pitcher and
remove it from the motor unit and make sure the spout and the
cut-outs are aligned.
Note: After blending for more than 30 seconds, unlock the
attachment and allow the motor to cool down for 2 minutes.

Using the Juice Extractor

1. Attach the chopping blade (H) to the base of the pitcher (A), screw it on
clockwise. Place the assembled pitcher on the motor unit.
2. Place the juice extractor (J) inside the pitcher. Insert juice extractor by lining up
the grooves on the extractor with the protruding guide lines inside the pitcher.
3. Put the lid on the pitcher and secure. Remove the clear inner cap (B) from the
lid. The fruits are inserted through this opening.
4. Insert fruit (if necessary, cut into smaller pieces to fit in the container) in the
opening in the top of the lid. Once fruits are loaded insert the pusher (K) into
the opening of the lid. Plug in the power cord into a wall outlet. Only touch the
plug with dry hands. Press down the pitcher and twist to lock on.
Operation
17