Entering The Edit Points; Entering In Points For The Player And The Recorder - Sony RM-450a Bedienungsanleitung

Entering the Edit Points

Note
The first IN point should be set on the tape following the preset preroll
time. The preroll time is set by using the PREROLL selector on the inside
panel.
Player OUT indicator
Player IN indicator
RESET
HOURS MINUTES SECONDS FRAMES
PLAYER
POWER
ON
STDBY EJECT
OFF
PLAY STILL REW FF
1
REVERSE FORWARD
SHUTTLE
1

Entering IN points for the player and the recorder

Press the PLAYER IN or RECORDER IN button simultaneously with
the ENTRY button at the desired point.
The PLAYER IN button is used for the player, and the RECORDER
IN button is for the recorder.
The corresponding IN indicator lights, and the OUT indicator blinks to
inform you that the OUT point should be entered.
2
Entering OUT point for the player or the recorder
Press the PLAYER OUT or RECORDER OUT button simultaneously
with the ENTRY button at the desired point.
The corresponding OUT indicator lights.
When the IN and OUT indicators blink alternately
The unit is informing you that both the IN and OUT points are entered at
the same tape point or that the OUT point is entered before the IN point.
Enter the correct edit points.
When you selected the CTL signal as the time data
Errors may occur when playing back a tape which is missing some CTL
signals or when repeatedly rewinding or fast-forwarding.
Recorder IN indicator
SERVO IN OUT IN OUT SERVO
EDITING CONTROL UNIT RM-450A HOURS MINUTES SECONDS FRAMES
ASMBL V A1 A2
EDIT MODE
– +
AUDIO SPLIT TRIM LAST EDIT
IN OUT GO TO IN OUT
PLAYER RECORDER
ENTRY
JOG
AUTO EDIT RVW
PREVIEW ALL STOP
/END /JUMP
Recorder OUT indicator
RESET TOTAL
RECORDER
REC EDIT STDBY EJECT
PLAY STILL REW FF
REVERSE FORWARD
2
SHUTTLE JOG
17