Philips HD 3454 Gebrauchsanweisung Seite 6

The fan will accelerate the flow of heated air,
especially if heat setting •• has been selected.
Do not forget to also set the thermostat dial (F) to
the required temperature.
Anti-Frost setting (fig. 10)
If e.g. a water pipe must be prevented from
freezing:
- Position the heater
(standing upright!)
close to the pipe;
- Switch the heater on
by selecting • or ••
(depending on the size
of the room, possible
draught and the
expected minimum
temperature);
- Set the thermostat dial to position y y (i.e. the
minimum thermostat setting, approx. +5 °C /
+41 °F). This position can be used to keep the
immediate vicinity of the heater free from frost.
Overheating safety device
To prevent damage and risks due to overheating,
the built-in overheating safety device cuts off the
power as soon as the heating elements become
too hot.
If this should happen:
- First ensure that it was not the thermostat which
has switched off the heater. Set the thermostat
to maximum position. If the heater does not
switch on, the safety device has been activated.
- Remove the mains plug from the wall socket.
- Let the heater cool down for 5 minutes.
- Replace the plug into the wall socket and switch
the heater on again.
If the safety device again switches off the heater:
- Have the heater inspected by a Philips Service
Centre or by your dealer.
10
Cleaning
- Before cleaning remove the mains plug from
the wall socket. Wait for the heater to cool down
sufficiently.
- You may clean the outside of the heater with a
damp cloth. Make sure that no water runs into
the appliance.
- The air inlet opening (A) and if necessary also
the air outlet opening(s) (B1, B2) may be
cleaned using the vacuum cleaner with small
long-haired nozzle.
Fitting a different plug
This appliance is fitted with a BS 1363 13 Amp.
plug.
Should you need to replace the plug, connect the
wires as follows:
Brown wire to the Live (L) terminal of the new
plug.
Blue wire to the Neutral (N) terminal of the new
plug.
Always fit the same value of fuse as that originally
supplied with your appliance.
Only use BS 1362 approved fuses.
As a guide only: Appliances under 700 W can
have a 3 Amp. fuse (red) and all others should
have a 13 Amp. fuse (brown).
When disposing of an old plug (particularly the
moulded type which has been cut from the mains
cord) always remove the fuse as the plug could be
dangerous if ever inserted in a live socket.
6
For U.K. only: