Bosch 0 607 561 114 Handbuch Seite 25

Circle Jig
32
You can make circular cuts up to a material thickness
of 30 mm (1.2 inches) by using the parallel guide with
circle jig 34.
Remove the locking screw 33 and flip the parallel
guide. Reinstall the locking screw on the other side.
Slide the scale through the cutting guide slot 32 of the
footplate 10. Pull off the centering tip 35 and place it
into the opening at the level of the saw blade. Bore a
hole in the center of the cutout in order to fix the
centering tip 35 in place and adjust the radius on the
inner edge of the footplate 10 by using the locking
screw 33.
Note: For tight curves, it is best to use narrow saw
blades.
3 609 929 250 • (04.07) T
34
33
Anti-Splinter Insert
36
10
10
35
The anti-splinter insert 36 reduces splintering of the
work piece surface during cutting.
Press the anti-splinter insert 36 into the footplate 10
from below. You may use the anti-splinter insert 36 for
the following types of saw blades: T 101 B, T 101 D,
T 244 D, T 301 CD, T 301 DL.
Cooling and Lubricating work pieces
When cutting metal, consider applying a coolant or lu-
bricant along the line of cut to reduce any heat that is
generated by the cutting process.
English–11